#21

Vintage Shaver
Seattle, WA
It seems the #8 nylon washers fit some but not all DE head posts, being slightly too small for some, so I'll need to pick up a few #10 washers too.

Matsilainen likes this post
John
#22

Member
Las Vegas, NV, USA
(11-21-2017, 07:42 PM)churchilllafemme Wrote: It seems the #8 nylon washers fit some but not all DE head posts, being slightly too small for some, so I'll need to pick up a few #10 washers too.
Good information, John.

I’ve tried the small orthodontic bands on a couple of razors other than the Blackbird, and I can say that they do not work. They, too, are too small, and when the handle is tightened, they get pushed into the opening in the bottom plate. Opening the razor head is no fun after that.
Whenever I go to shave, I assume there’s someone else on the planet shaving, so I say “I’m gonna go shave, too.”
– Mitch Hedberg
#23
(11-21-2017, 07:42 PM)churchilllafemme Wrote: It seems the #8 nylon washers fit some but not all DE head posts, being slightly too small for some, so I'll need to pick up a few #10 washers too.

Nylon #10s have always worked for me. I've always used them when combining different handles and heads. They work great.

stuartganis74 and Matsilainen like this post
#24

Vintage Shaver
Seattle, WA
I guess there is a learning curve involved here, at least with my aging little grey cells. I forgot about the washer this morning and lost it down the sink drain when I took my razor apart to rinse it. I have some spares, but I need to focus a little better.

Matsilainen likes this post
John
#25

Member
Las Vegas, NV, USA
I'm actually surprised I've never lost one, so far. churchilllafemme, if you like them and continue to use them, I'm sure you'll soon begin to remember them as part of your regular setup.
Whenever I go to shave, I assume there’s someone else on the planet shaving, so I say “I’m gonna go shave, too.”
– Mitch Hedberg
#26

Vintage Shaver
Seattle, WA
OK, call me picky, but I decided to pick up some rubber washers, which I like better than the nylon ones for some reason.   And just a word to the wise, small black washers are a lot easier to see on a light-colored bathroom counter than white ones...

Matsilainen likes this post
John
#27
I rinse the razor while assembled as water seeps into all corners & crevices. I then disassemble on a paper napkin and pat dry leaving everything laid out until I return from work in the evening when all is bone dry & then I reassemble. No losing parts down the sink or dropping parts in the sink either with my method. Every so often I place the parts in a cup with rubbing alcohol to clean off soap scum. Before shaving is when I lay out said napkin on the kitchen counter whereas I fit the blade before sauntering into the bathroom.

As I have grown older I have become a creature of habit and I try to be extremely methodical. Wink

Matsilainen likes this post
Secretary Ramsey put his foot into it yesterday . . . in the course of his remarks he said that California “needs water and better society.”  “So does h-ll,” yelled someone in the crowd.  


Users browsing this thread: 1 Guest(s)