#1
Hey guys i have a gem macromatic open comb brass i bought on ebay cheap . Someone can tell me about echo delta razor restoration?
Thank you

Mickey ObermanSfZ2h8UM likes this post
#2
they do really good job, many color options

Mickey ObermanSfZ2h8UM likes this post
#3
They do a good job, but keep in mind that its not a restoration like what you get from Razor Emporium. When you send one to Razor Emporium for replating, it is disassembled and restored. Delta Echo just puts a coating on an old razor. I had a GEM Bullet Tip coated by Delta Echo, but in the end I found that the GEM Bullet tip that I bought NOS (New Old Stock)was a better shave for roughly the same cost. Unless you are after a razor in a specific color, I'd recommend finding one that was NOS.

Mickey ObermanSfZ2h8UM likes this post
#4
(This post was last modified: 05-03-2018, 09:26 PM by Blagoja Rajevski.)
(05-03-2018, 07:55 PM)Nuki Man Wrote: They do a good job, but keep in mind that its not a restoration like what you get from Razor Emporium. When you send one to Razor Emporium for replating, it is disassembled and restored.  Delta Echo just puts a coating on an old razor.  I had a GEM Bullet Tip coated by Delta Echo, but in the end I found that the GEM Bullet tip that I bought NOS (New Old Stock)was a better shave for roughly the same cost.  Unless you are after a razor in a specific color, I'd recommend finding one that was NOS.

I doubt Micromatics are being disassembled, from what I have heard all that tried to disassemble one if they were able to assemble it, it didn't function as it should

Mickey ObermanSfZ2h8UM likes this post
#5
The razor is working perfect right now the plating is off and its brass with some patina that i Can clean . So i guess i wont mess up the razor and enjoy the shaves.

What kind of cleaning solution i can use for the razor? Its brass

Mickey ObermanSfZ2h8UM likes this post
#6
(05-03-2018, 11:13 PM)Ernesto89 Wrote: The razor is working perfect right now the plating is off and its brass with some patina that i Can clean . So i guess i wont mess up the razor and enjoy the shaves.

What kind of cleaning solution i can use for the razor? Its brass
warm water, dish soap, few drops of vinegar, let it sit for an hour and then scrub it off with old tooth brush that you don't use anymore. If you worry about disinfecting it, then poor some isopropyl on it and your good to go to shave with it.

I did this to all my vintage razors when I got them, they were anything but clean and some needed tweaking



[Image: riGN94D.jpg]


[Image: CB2KlEj.jpg]

Fedsbackhand and Mickey ObermanSfZ2h8UM like this post
#7
Soap water and vinegar will remove the green spots on the brass?

Mickey ObermanSfZ2h8UM likes this post
#8
(05-04-2018, 02:26 AM)Ernesto89 Wrote: Soap water and vinegar will remove the green spots on the brass?

at least 90% of the green spots

Mickey ObermanSfZ2h8UM likes this post
#9
Ok . Thank you !!

Mickey ObermanSfZ2h8UM likes this post
#10
(This post was last modified: 05-04-2018, 11:52 PM by Mickey ObermanSfZ2h8UM.)
Ernesto89#1

Think of your GEM Micromatic as a precious antique the value of which would be destroyed if the signs of its use and antiquity were removed.

And think of the many eager hands that enjoyed using it just as you do and will do.

Mickey


Users browsing this thread: