Recommend me a good 'stache wax

BadDad, thanks I might have to try that. Cheaper than 'stache wax too!

The really cool part is, mid-day, if it starts to "flop", just grab your mustache comb, run it under a bit of water, and it will soften the glue and allow you to reset it!

Just don;t use too much water or you end up combing it right out of the hair...

BadDad, I've been using the glue stick for the past couple days and it holds very well. However, I noticed it leaves some flaky white residue that is visible in my 'stache. Has this ever happened to you? Any other tips? Thanks!

BadDad, I've been using the glue stick for the past couple days and it holds very well. However, I noticed it leaves some flaky white residue that is visible in my 'stache. Has this ever happened to you? Any other tips? Thanks!

I have not had this issue. My first thought is maybe you aren't combing it through well enough. I apply the glue to freshly washed and oiled moustache, then comb it through with a fine Kent moustache comb. Then I hold it gently in place for about 45 seconds until the glue "sets", and I'm out the door.

If the flakes are appearing after the glue has set and dried, try wetting your moustache comb and running it through again to reduce the amount of glue...

BadDad, Ok thanks. Do you just rub the glue stick on your mustache or scrape some glue off with your fingernail and work it in by hand? I applied it by rubbing it on.

It could be because I bought the el cheapo stick and not Elmer's. The only Elmer's they had was some "Crazy purple that dries clear". I didn't feel like experimenting with some purple glue in my 'stache.

wyze0ne I just rub the stick directly on the stache. And I am using a generic Avery brand at the moment, for the same reason, actually...

wyze0ne I just rub the stick directly on the stache. And I am using a generic Avery brand at the moment, for the same reason, actually...

LOL, thanks again man!