#11
Edited the original post with picture of the 2nd case
#12
(06-12-2017, 11:48 PM)Blagoja Rajevski Wrote: Hey just wanted to share something I did this afternoon since the last order was delivered from ebay so I could jump on the project. Its a large carry case for GoPro and recycled foam. I ordered 2 cases and 2 piece of foams and cost for a case and foam is around $15.




Here how it came out and later on after the gym I will work on the other case that will have Gem vintages, couple of Fatips and couple Indian TTO's




[Image: IMG_1103_zpscafd0vdv.jpg]

[Image: IMG_1104_zps7pqb3rxc.jpg]


Very nice! May I ask what you used to cut the foam, and how you made sure the cutouts were the right side? Sorry if this is basic, but I'm mechanically challenged!
All the best,

Michael P
#13
(06-13-2017, 09:01 PM)Michael P Wrote:
(06-12-2017, 11:48 PM)Blagoja Rajevski Wrote: Hey just wanted to share something I did this afternoon since the last order was delivered from ebay so I could jump on the project. Its a large carry case for GoPro and recycled foam. I ordered 2 cases and 2 piece of foams and cost for a case and foam is around $15.




Here how it came out and later on after the gym I will work on the other case that will have Gem vintages, couple of Fatips and couple Indian TTO's




[Image: IMG_1103_zpscafd0vdv.jpg]

[Image: IMG_1104_zps7pqb3rxc.jpg]


Very nice! May I ask what you used to cut the foam, and how you made sure the cutouts were the right side? Sorry if this is basic, but I'm mechanically challenged!
first I laid the razors in order I want to figure out the distance and layout, then I remove the razors and start laying each razor,drawing line around it with pen, cut inside the line and gradually form the inside and test how the razor fit. Once I get the satisfactory result then I move onto the other razor with the same method, here is what I use to do the cutting https://www.walmart.com/ip/X-Acto-Craft-Knife/23081586
#14
(This post was last modified: 06-14-2017, 02:17 AM by jmudrick.)
I'm leaving for two months in Cambodia and Vietnam tomorrow and using the Rockwell case which will accommodate unmodified:

Rockwell handle/5-6 plate
R41 head
Pearl/SABI heads
1912 head
1924 head
Scum brush, 10/32 set screws, shims, dessicate packet

Pretty handy way to carry six razors :-)
[Image: aebc20e681602d83f1ce865487fc6ca5.jpg]

Sent from my Nexus 5X using Tapatalk

Blagoja Rajevski, Rebus Knebus and Blade4vor like this post
#15
Like what you have done there, great idea. Been thinking about trying this or something like this with a small Pelican case. More for a travel type shave kit that would hold a razor, pack of blades, nail clippers, small mustache trimming scissors and such.

jmudrick likes this post
#16
Thanks, Blagoja Rajevski It's a very handsome case and the display looks really good as well!

Blagoja Rajevski likes this post
All the best,

Michael P
#17
thank you

Michael P likes this post


Users browsing this thread: 1 Guest(s)