#1

Member
Texas
Hey Guys,

I recently bought a black ark from Dan’s as a finishing stone and I am trying to figure out what I need to do next. I have read that some people will use a diamond plate, about 400 grit, and WD paper up to 4000 grit to smooth it out and then apply some polish. I was wondering if y’all had any advice or possibly tutorials on how to go about this. 

Thanks for y’all help!

Dave in KY likes this post
#2
(10-06-2020, 03:47 PM)Patelliott Wrote: Hey Guys,

I recently bought a black ark from Dan’s as a finishing stone and I am trying to figure out what I need to do next. I have read that some people will use a diamond plate, about 400 grit, and WD paper up to 4000 grit to smooth it out and then apply some polish. I was wondering if y’all had any advice or possibly tutorials on how to go about this. 

Thanks for y’all help!

I haven't watched the vid, and my only black ark is an old norton that didn't need prep. Anyway ... here ya go ;

https://www.youtube.com/watch?v=v_VVIhzvmEA

Patelliott and Dave in KY like this post
#3

Member
Texas
(10-06-2020, 05:40 PM)JimmyH Wrote:
(10-06-2020, 03:47 PM)Patelliott Wrote: Hey Guys,

I recently bought a black ark from Dan’s as a finishing stone and I am trying to figure out what I need to do next. I have read that some people will use a diamond plate, about 400 grit, and WD paper up to 4000 grit to smooth it out and then apply some polish. I was wondering if y’all had any advice or possibly tutorials on how to go about this. 

Thanks for y’all help!

I haven't watched the vid, and my only black ark is an old norton that didn't need prep. Anyway ... here ya go ;

https://www.youtube.com/watch?v=v_VVIhzvmEA

Thank you!
#4
I definitely recommend SiC powder progression!

That’s a good video!

Vr

Matt

Patelliott and Dave in KY like this post
#5

Member
Texas
(10-06-2020, 11:16 PM)Ols67 Wrote: I definitely recommend SiC powder progression!

That’s a good video!

Vr

Matt
Thank you!

Dave in KY likes this post
#6

Member
Texas
I had the same question. Thanks for starting the thread  Patelliott

Dave in KY and Patelliott like this post
#7

Member
Texas
(10-07-2020, 03:53 AM)MilkCrate Wrote: I had the same question. Thanks for starting the thread  Patelliott

No problem Tim!

Dave in KY likes this post


Users browsing this thread: 1 Guest(s)